Stump Grinding Brisbane

Stump grinding in Brisbane is the quickest way to get rid of a tree stump for good: a machine with a spinning carbide wheel chews the stump into chips, well below ground level, so you can lay turf, build a fence or plant over it the same week. Dynamic Tree Solutions grinds stumps across Brisbane’s southside, Logan and Ipswich from our Ellen Grove yard, with tracked grinders narrow enough for a side gate and bigger machines for acreage and commercial sites. Qualified arborists, fully insured, and we take the mess with us.

Got a stump in the way? Call 1300 239 626 or send a photo through the quote form and we’ll price it from the picture.

What is stump grinding, and how deep do you go?

A stump grinder is a cutter wheel studded with carbide teeth, mounted on a tracked or wheeled machine. The operator sweeps the wheel back and forth across the stump, taking it down a few centimetres at a time, until the stump and the top of the root plate are chips. The hole gets backfilled with the grindings, or with soil if you’d rather, and you’re left with a flat patch of ground instead of a trip hazard.

As standard we grind to around 200 to 300 mm below the surface. That’s enough for lawn, garden beds and paving. If you’re putting a slab, a pool or a fence post exactly where the tree was, tell us and we’ll go deeper and chase the main roots out. Deeper costs a bit more time, so it’s worth saying up front rather than finding a root when the post-hole digger does.

Stump grinding or stump removal: which one do I need?

People use the words interchangeably. They’re not the same job.

Stump grindingStump removal (dig-out)
What happensStump ground into chips below ground level; roots left to rotWhole stump and root ball pulled out with an excavator
MessA pile of chips, a shallow holeA crater, a lot of soil, tracks across the yard
Time on siteMinutes to an hour for most backyard stumpsHalf a day plus, and the machine has to get in
Best forLawns, gardens, fences, paving, tight backyardsBuilding slabs, pools, land clearing for development

Nine times out of ten, grinding is the answer for a house block. We’ve written a longer comparison on stump removal versus grinding if you want the detail. If the whole tree is still standing, start with our tree removal page; we can grind the stump the same visit.

Why bother getting the stump out at all?

  • Termites. A dead stump with its roots in the ground is a buffet with a front door. In South East Queensland the termite swarms start around November, and a stump 10 metres from the house is exactly where a colony sets up before it finds the bottom plate. Grinding takes the food source away.
  • Regrowth. Camphor laurels, umbrella trees, poincianas and plenty of gums will throw suckers off a cut stump for years. Grind the crown of the stump out and the suckering stops.
  • The mower. Everyone who’s clipped a stump with a ride-on knows this one.
  • Space. A stump is dead ground. Grind it and you get the fence line, the garden bed or the shed pad back.
  • Selling the place. Buyers see a stump and think “what else hasn’t been finished”.
DTS operator in orange shirt and helmet running a tracked Vermeer stump grinder by remote in a Brisbane backyard
Backyard job on the southside: tracked grinder in through the side gate, operator on the remote, stump gone before smoko.

Can you get a stump grinder into my backyard?

Almost always. The machine we use most around Brisbane’s suburbs is a Vermeer SC60TX, a tracked grinder narrow enough to fit through a standard side gate and light enough not to wreck the lawn on the way through. It’s driven by remote, so the operator stands clear of the chips and can see what the wheel is doing from the best angle instead of the only angle. For acreage, big stumps and commercial sites we run a bigger Rayco grinder and, where the stump is a monster, the excavator with a grab.

If the only way in is a 750 mm gap between the house and the fence, send a photo with a tape measure in it and we’ll tell you straight whether the grinder fits. If it doesn’t, there are smaller options and there’s always the slow way with hand tools, but we’d rather tell you that before the truck turns up than after.

Vermeer SC60TX tracked stump grinder squeezed into a narrow side yard between a brick house and a fence in Brisbane
Tight side yard, brick wall one side, fence the other. The tracked grinder went in and did the job without a scratch on either.

What happens to the grindings?

Stump grindings are wood chip mixed with soil. Most people have us rake them back into the hole and mound it slightly, because the mix settles as it breaks down. If you’re laying turf straight away, ask us to take the chips and leave a soil-ready hole, or bring a barrow of topsoil for the top. Grindings from a healthy tree are fine in a garden bed as rough mulch; grindings from a diseased tree are better off in the green bin or on our truck.

One thing people don’t expect: Brisbane, Logan and Ipswich sit inside the fire ant biosecurity zone, and there are rules about where soil, mulch and similar material can be moved and how quickly it has to be used. We handle that side compliantly. If you’re carting the grindings somewhere else yourself, have a look at the fire ant movement controls first.

Do I need council approval to grind a stump?

Once a tree has been lawfully removed, grinding what’s left is your business and no permit is needed. The approval question belongs to the removal, not the stump, and it depends on which council you’re in:

  • Brisbane City Council: check the Protected Vegetation map before the tree comes down. A tree whose trunk is within 3 metres of the house on a normal block, or a trunk under 30 cm across at 1.4 metres in a garden, doesn’t need a permit, and permits are free when one is required. Our Brisbane council tree rules page has the plain-English version.
  • Logan City Council: most house blocks under 5,000 square metres outside environmental or rural zones are exempt, and cadaghi and umbrella trees are exempt everywhere. See Logan council tree rules.
  • Ipswich City Council: approval can depend on your zone and overlays under City Plan 2025, so check ePlan or ring council. See Ipswich council tree rules.

If the stump is from a tree that came down in a storm, the same applies. Brisbane council does want photos and an arborist’s report within 10 business days if a protected tree was removed as an immediate hazard, and we can write that for you.

What about pipes, cables and sprinkler lines?

A grinder wheel doesn’t care what it hits, so we care for it. Before the machine starts we ask about irrigation, the sewer line, stormwater, the old clothesline footing and anything else that might be under there. For stumps near the boundary, the driveway or the street we lodge a free enquiry with Before You Dig Australia so the service plans are on the phone before the wheel is on the ground. Sprinkler pipes are the usual casualty on house blocks; if you know where yours run, show us, and if you don’t, tell us that too.

How does a stump grinding job run?

  1. Photos and a price. Send a photo of each stump with something for scale, tell us the suburb and how we get in, and we’ll quote from that. For a yard full of stumps or anything commercial, we come out and look.
  2. Book it. Most backyard jobs are a short visit, so we fit them in around tree work in the same area. If we’re already removing the tree, the grinder comes on the same truck.
  3. Walk the site. Where are the services, where do the chips fly, what’s the access, where does the dog go.
  4. Grind. Guards up, operator on the remote, stump taken down in passes to the depth you need. Big surface roots get chased out as far as makes sense.
  5. Tidy up. Grindings raked into the hole or loaded out, lawn blown off, gate shut behind us.

A recent acreage job, the one in the photo below: a line of old gum stumps along a fence, each one the size of a table. The wheeled Rayco did the lot in a morning, grindings mounded over each hole, and the owner was fencing through them the next weekend.

Rayco RG55 stump grinder parked on a freshly ground gum stump on an acreage block near Brisbane, house and caravan behind
Acreage stump ground out and mounded. The bigger wheeled grinder for bigger stumps and open ground.

Where do you grind stumps?

We’re based at Ellen Grove, next door to Forest Lake, so Brisbane’s southside and west, all of Logan and all of Ipswich are home ground. Regular stump runs cover Forest Lake, Greenbank, Park Ridge, Jimboomba, New Beith, Springfield, Goodna, Redbank Plains, Collingwood Park and Camira, plus the rest of Logan and Ipswich.

If all you need is a stump done and nothing else, our stump-only sister company All Sites Stump Grinding runs a dedicated grinder across Brisbane and Ipswich. Same people, same standard; it just means a stump on its own doesn’t have to wait for a tree crew to be in your area.

How much does stump grinding cost?

It comes down to the diameter of the stump at ground level, how many there are, how deep you need it, how far the roots run and how hard it is to get the machine in. A single stump in an open front yard is a quick job; six stumps behind a pool fence up a flight of steps is not. We don’t quote blind and we don’t do surprise extras: send photos, get a fixed price, decide. There’s more on what moves the number in our stump grinding cost guide.

Get a stump grinding quote

Call 1300 239 626, or put your suburb and a photo of the stump in here and we’ll come back with a price.

    Tree Pruning & MaintenanceTree RemovalEmergency & Storm ResponseCivil Projects

    Stump GrindingLand Clearing & FirebreaksCommercial Tree Services

    Stump grinding Brisbane: common questions

    How long does stump grinding take?

    Most single backyard stumps are ground out in well under an hour once the machine is in position. Large gum stumps, a row of them, or a deep grind for a slab take longer. We’ll tell you when we quote.

    Will the roots keep growing after the stump is ground?

    No. Without the stump and the crown of the root plate the roots have nothing to feed, and they rot away in the ground over a few years. The exception is a few suckering species that need the grind taken a bit deeper, which we do as a matter of course.

    Can I plant a new tree where the old stump was?

    Yes, but give it a season or dig out the grindings and backfill with soil first. Fresh wood chip pulls nitrogen out of the ground as it breaks down and a new tree planted straight into it will sulk. Planting a metre or so to the side is easier.

    Can you grind a stump that’s right against a fence or a wall?

    Usually. The cutter wheel can work up close and we grind what we can reach safely, then chase the rest by hand if it matters. Against a retaining wall we’ll have a look first, because roots and retaining walls have often become one thing.

    Do you grind palm stumps?

    Yes. Cocos palm stumps are soft and fibrous and grind easily, which is the one nice thing about Cocos palms. See our palm removal page if the palm is still standing.

    Do you take the grindings away?

    Your call. Most people have them raked back into the hole. If you want a clean hole for turf or a slab, we load the chips out and leave it ready for soil.

    Call Now Button
    Review us on Google